Description
Made of solid brass.
Simple geometric forms, versatile application.
Transitional design – works in modern or traditional setting.
Easy to install with 8-32 machine screws provided.
Goes well with Square Bar and Round Bar Series.
12" Two-Tone Pull
in Brushed Brass Finish with Matte Black Post
Length: 12"
Center to Center (hole spacing): 10"
Bar Thickness: 1/4 x 7/16"
Projection: 1-1/16"
Product #31-514
View entire Two-Tone Pull Collection
Specifications
Material: Solid Brass
Length: 12″
Center-to-Center (hole-spacing): 10″
Projection: 1-1/16″
Bar Thickness: 1/4″ x 7/16″
Warranty: 1 year limited warranty
Shipment Weight: 13 oz.
California Residents: WARNING: see Proposition 65 information
Included Hardware
Includes (4) 8-32 machine screws, (2) 1″ & (2) 1-1/2″ long, depending on the thickness of door/drawer
Product Care
- Use a soft, nonabrasive, slightly damp cloth for cleaning cabinet knobs/pulls and dry immediately. If your water contains higher than normal levels of salt or other chemicals, please used distilled water to dampen the cloth.
- Never use any abrasive materials such as steel wool or Scotch-Brite pads for cleaning. This can compromise the protective lacquer finish and void the warranty.
- Never use any cleaning agents with bleach or other chemicals that can remove the protective finish and cause the solid brass material to oxidize and discolor, which will also void the warranty.
- Warranty limited to one year from date of sale against defects in material or workmanship, under the intended use of the product. Our sole responsibility is to repair or replace defective merchandise.
- Please note that in areas near bodies of water where there is a higher salt content in the air, this may have a corrosive effect on solid metal items. Manufacturer maintains the right to void the warranty under these circumstances.
Installation
Place knob or pull in desired position on cabinet and mark holes to be drilled.
Before drilling, please make sure to take into account that the holes in the post are 5/16″ off the center of the knob/pull. See diagram for clarification.
Before drilling, please make sure to take into account that the holes in the post are 5/16″ off the center of the knob/pull. See diagram for clarification.
